Water Heater Installation & Replacement
Professional tank and tankless water heater installation and replacement for homes and properties throughout Miami and South Florida.
Professional Water Heater Installation & Replacement
A properly installed water heater depends on more than simply replacing the appliance. Existing water connections, shutoff valves, venting, drainage, pressure, electrical or gas connections and the installation location all need to be evaluated.
Jay & Norman Plumbing Services can remove an existing water heater and install an appropriate tank or tankless replacement, including required plumbing connections, testing and system startup.
- Tank water heater replacement
- Tankless water heater installation
- Gas and electric systems
- Hot and cold connections
- Venting evaluation
- Final testing and startup
Signs Your Water Heater May Need Attention
A water heater problem can affect comfort, energy use and surrounding areas of the property. An inspection can help determine whether repair or replacement is appropriate.
No Hot Water
A heater that is no longer producing hot water may require diagnosis, repair or replacement depending on the cause.
Water Around the Heater
Moisture or water around the tank, valves or piping should be inspected to determine where the leak originates.
Inconsistent Temperature
Water that becomes unexpectedly cold, excessively hot or inconsistent can indicate a system problem.
Unusual Noises
Popping, rumbling or unusual sounds from the unit can be a reason to have the water heater evaluated.
Corrosion or Deterioration
Visible deterioration around the tank, valves, fittings or connections may indicate that service is needed.
Frequent Repairs
A system requiring repeated service may be evaluated to determine whether replacement is the better option.
From Old Water Heater to Tested New Installation
Installation requirements vary by water heater type, fuel source, property and existing plumbing conditions.
Shut Down & Inspection
Water, gas or electrical supply is safely shut down as applicable. The existing heater, valves, piping, platform, drain arrangement and venting are reviewed before removal.
Drain & Remove Existing Unit
The existing water heater is drained, disconnected and removed so the installation area and existing connections can be prepared for the replacement unit.
Install New Water Heater
The replacement tank or tankless heater is positioned and connected according to the selected system, available space and existing plumbing configuration.
Plumbing & Safety Connections
Hot and cold water connections, shutoff valves, T&P discharge, drain pan, expansion components and related fittings are addressed where required by the installation.
Gas, Electrical & Venting Check
Applicable gas or electrical connections are tested, and venting is reviewed for the selected water heater configuration.
Fill, Purge, Test & Start
The system is filled and purged, connections are checked for leaks, operation is tested and the thermostat is typically set around 120°F unless another appropriate setting is required.
Tank or Tankless? Installation Options
The appropriate system depends on available utilities, property conditions, hot-water demand, installation space and existing connections.
Traditional Tank Water Heaters
Tank systems store a ready supply of hot water and are available in different capacities and configurations.
- Common 30, 40 and 50 gallon options
- Gas or electric models
- T&P relief valve and discharge setup
- Drain pan and drain where applicable
- New water connections where required
- Shutoff / ball valve connection
Tankless Water Heaters
Tankless systems heat water as needed and require installation based on the property's hot-water demand and available gas or electrical capacity.
- Unit sizing based on application
- Isolation valves where applicable
- Condensate drainage when required
- Venting according to unit configuration
- Scale filtration where appropriate
- Final flow and performance testing
More Than Just Changing the Heater
Existing plumbing conditions are reviewed so the new unit can be connected, tested and started appropriately.
Connections, Venting, Pressure & Testing
The requirements for each installation depend on the selected unit and the conditions found at the property.
Venting
Applicable venting is reviewed for gas-fired tank and tankless systems.
Water Pressure
Excessive incoming water pressure may require a pressure-reducing solution.
Gas / Electrical
Existing gas or electrical connections are reviewed and tested as applicable.
Permit / Inspection
Permit and inspection requirements can be addressed where required for the installation.
Water Heater Installation Scope of Work
Final scope depends on the water heater selected and conditions found at the property.
Installation May Include
- Shutoff, draining and disconnection of the existing water heater
- Removal of the existing unit
- Installation of tank or tankless replacement
- Hot and cold water connections
- New flex lines or suitable piping connections where required
- T&P relief valve and discharge connection
- Drain pan and drainage where applicable
- Gas or electrical connection testing
- Venting connection where applicable
- Filling, purging and leak testing
- System startup and operating check
- Cleanup of the immediate work area
May Require Separate Pricing
- Drywall or tile restoration
- Major plumbing rerouting beyond approximately six feet
- Electrical panel upgrades
- Major gas-line modifications
- Structural modifications
- Permit fees unless specifically included in the quote
- Additional work discovered after removal of the existing heater
Final Testing & Startup
After installation, the water system is filled and purged, accessible connections are checked for leaks and the unit is tested for operation. A typical initial thermostat setting is approximately 120°F, subject to the system and customer requirements.
Warranty
Manufacturer warranty applies according to the selected water heater. Installation includes a 1-year labor warranty based on the agreed scope of work.
Serving Miami & South Florida
Contact Jay & Norman Plumbing Services to confirm water heater installation or replacement availability for your property.
Water Heater FAQs
Do you install both tank and tankless water heaters?
Do you install gas and electric water heaters?
What tank sizes can be installed?
Will you remove the old water heater?
Is an expansion tank always required?
Do you check the water pressure?
Do you provide a warranty on the installation?
Do you provide water heater service throughout South Florida?
Need a New Water Heater? Call Us Today.
Tell us about your current water heater, the problem you are experiencing and your property location. We can discuss the appropriate next step for replacement or installation.